Sunday, September 20, 2015
Pulse shaper
In the construction of generators, timers and other similar devices generally used RC-Timing chain, whose work is based on the charge and discharge of the capacitor through a resistor from the dc source. These RC-circuit is connected, as a rule, the various active devices - transistors, op amps, comparators. The device, a circuit diagram is shown in Fig. 1 forms any desired number of pulses in the range from 1 to 10. It can be used in apparatus control operation of the digital nodes, encoder codes or commands, switches, and so on. N. From the known devices of this purpose shaper is simple construction, a small number of integrated circuits, as well as small (less than 4.5 mW) power consumption, it can be used in devices with independent power supply. The generator is connected to the separation (buffer) amplifier. A small capacitor can be used to adjust a specific quartz crystal at exactly vydefief frequency. In the development of digital devices often required to generate pulses that are linked to the input signal. If you do not meet high requirements for stability and duration of the pulse can be applied on the basis of the differentiating circuit (Fig. To generate pulses having the required parameters and ensure that the potential isolation of power and control circuits Applyconditioners are built on the basis of opto-electronic or transformerregulatory elements. Fig.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment